Asoka PlugLink Guia do Utilizador descarregar pdf (Página 33)

33 of 40

Note: Write this information down in your Warranty Support Information

card for future reference.

Buttons



The PlugLink HD AV Adapter device has two hardware push buttons:

• FW RST (Firmware Default Reset ) button – Resets the PlugLink HD AV

Adapter back to factory default settings. Press and hold the button with a

pin or sharp object for about 2 seconds until you see the lights on the device

flash briefly.

• SECURITY (Network ID) button – All PlugLink HD AV Adapter devices have a

default password Network Encryption Key (NEK) set to “HomePlugAV”

allowing them to communicate to each other. The SECURITY button allows

you to set a devices’ password to a randomized Network Encryption Key

(NEK) for maximum security. You can then set other devices to the same

NEK by using their SECURITY button. Only units with the same NEK can

communicate to each other.

SETTING A RANDOMIZED NETWORK PASSWORD



   



1. Select a PlugLink HD AV Adapter (Device A) and plug into an AC outlet. The

POWER light indicator should be lit solid green.

a. Press the SECURITY button BRIEFLY (1 second) and release. The

POWER light should now be blinking green.

b. IMPORTANT: If the POWER light is not blinking green, repeat Step “a”

until the power light blinks green.

c. This unit is now ready to create a new randomized NEK (Net

Encryption Key) network. This unit will remain in this “adder” mode

Ethernetlight

PLCACTlight

Powerlight

DeviceA DeviceB

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Sem comentários

Asoka PlugLink Guia do Utilizador Página 33